2008-2012 Mitsubishi EVO-X Fujita Short Ram Intake

Fujita Competition Air Intake Systems

See below what makes our intakes different from the rest.  Fujita Air Intakes are based on high performance design matched with high quality manufacturing to create a superior product.

6061 T6 Aluminum Alloy Construction	Carbon Plated T-Bolt Clamps
Each Fujita intake system is made with 6061 T6 Aluminum Alloy. After each application is bent and inspected, we polish it for an extremely bright finish.	Carbon Plated T-bolt Clamps are used in our applications due to their strength and reliability. All of our T-bolt Clamps either meet or exceed the SAE Spec. J1508.
Silicone Hose	Tig Welded Brackets
We use reinforced Silicone Hose to provide stability during both extreme hot and cold conditions, -65°F(-54°C) to +500°F (+260°C)	TIG Welded brackets are used in conjunction with Rubber Vibration Mount Dampening to stabilize the intake system from unwanted stress during load.
CNC Machined Fittings	Super Flow Performance Air Filter
CNC machined air mass sensor fittings are used to ensure proper air/fuel ratios throughout the power curve. Each sensor is carefully engineered for accuracy	Each Fujita Intake System comes with a Super Flow High Performance Air Filter designed to maximize efficiency without compensating air filtration.

COLD AIR INTAKE SYSTEMS
A Cold Air Intake is traditionally longer and in most cases extended behind the bumper cover so that it can ingest direct air that is both cooler and denser. In addition to more direct air, the longer plenum achieves higher torque gains as well as impressive horsepower figures. Depending on the complexity of the plenum route, the Fujita Cold Air Intake may come as a 1 piece or 2 piece intake system. Different diameters, filters, and bends are all key factors of the R&D process of each Cold Air Intake. The in-house Dynojet is the final judge of which intake configuration will make it to production. Air/Fuel ratios are also an important factor in testing the Cold Air Intake, ensuring that safe and near factory levels are maintained in order to not trip any electronic sensors on the vehicle.

SHORT RAM INTAKE SYSTEMS
A traditional underhood intake, also known as a Short Ram Intake, usually follows the same path as the stock intake system. There are some distinct differences between the stock intake and the Fujita Air Short Ram. A few of these differences include replacing the factory intake plenum with an aluminum plenum, eliminating resonators, air box, drop in filter, and replacing it with an open filter element. These key differences allow the vehicle to bring in more air into the intake chamber and create more horsepower and torque. Vacuum and in some cases air mass sensors, are still maintained and incorporated into the Fujita Short Ram Intake. Since a vehicle is constantly moving (except during traffic or at a light) heat soak will be of little issue since the car will constantly be bringing in fresh air. In addition, studies have shown that the material used to build the intake system has shown no loss of horsepower due to an intake being rubber, aluminum, ceramic coated, anodized, etc.

EACH FUJITA INTAKE SYSTEM COMES COMPLETE WITH:6061 T6 Aluminum Intake Tubing with Polished finish *except special editions

• Reinforced Silicone Hose
• Carbon Plated T-bolt clamps *unless linear clamps are required
• Fujita Super Flow High Performance Air Filter
• TIG Welded bracketry
• Vibration Mounts